Rear Bumper Reflector Pre-cut Overlay Tint for 2021-2025 Lexus is 300 350 500

Improve the appearance of your 2021-2025 Lexus IS 300, 350, or 500 with AFDOverlays Rear Bumper Reflector Pre-cut Overlay Tints. Offered in Dark Smoke, Black Out, and Light Smoke, these tints provide a refined yet assertive aesthetic. Engineered for straightforward peel-and-stick application, they ensure a seamless fit that enhances your vehicle’s rear profile with precision and ease.

Specifications:

• Fitment: For 2021, 2022, 2023, 2024 2025 Lexus IS 300, 350, 500, 350 F-sport, and 500 F-sport models Rear Bumper Reflector Pre-cut Overlay Tint in Smoked, Light Smoked, or Black Out.
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
• Made with Durable High Gloss Material with Nano Air-Release
• Easy Application (Peel and Stick)
• Comes in (2 PCS) in a Pair (left and Right Rear Bumper reflector tint smoked out)
• ** NOTE ** Not Actual Rear Bumper Reflector Replacement. This product is an overlay that covers the existing rear tail light brake running lights with a vinyl tint.

How to Install

For Best Results

Tools: Heat Gun or Blow Dryer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your Rear Bumper Reflector to get rid of debris before application
2. Peel off one piece of the tail light tint at a time.
3. Note: If you mess up placement, peel off the overlay with ease. DO NOT heat up the overlay until the desired placement has been met.
4. Whichever piece you decide to peel and stick on first, align the edge that is closest to the middle of the bumper, the top corner. Depennding on how your reflector sits, if its more sunk in then align it directly at the edge, if it protrudes more - then cover a the reflector a bit more over the edge so it can wrap around it.
   
5. Once aligned at the edge that points away from the front of the car, the rest should fall into place. Adjust the placement if needed till it fits around the entire reflector.
6. Depending on how you install it, it may go over the actual reflector due to your pulling or laying, but it will generally fit into place.
7. Best practice is to tack down one edge of the overlay and use your free hand to guide the rest of the overlay by matching the edges of the reflector all around and check to make sure all of the red is covered.
8. As you guide the overlay, use your other free hand to lay and swipe the overlay onto the reflector, by pushing out any bubbles towards the closest edge.
9. Once laid the rest of the overlay should fall into place.
   
10. Once the placement is met, PLEASE FOLLOW THE BELOW INSTRUCTIONS FOR ADHESION
11. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
12. If there are bubbles, make sure you press firmly with your finger and swipe it toward the closest edge
13. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
14. ** REMEMBER TO POST-HEAT** the vinyl after laying, this will activate the glue behind the overlay which will enhance tackiness.
15. NOTE:  Gloss Black has PET liner, which must be peeled off after install for a complete super gloss finish.