Turn Signal Pre-Cut Overlay for Hyundai Elantra N 2021-2023

Customize your Hyundai Elantra N 2021-2023 with this turn signal pre-cut overlay in a choice of five stylish tints. Enjoy a unique, custom look without any complicated installation. Crafted from high-quality materials, these overlays will stand the test of time and offer a new and enhanced look to your Hyundai Elantra or Elantra N.

2021+ Hyundai Elantra N / Elantra Tail Light Side Marker (Smoke or Black Out)

• Fitment : [ 2021+ Elantra N and Elantra]
• Turn Signal of Hyundai Elantra N
• High-Quality durable material. 5-year durability 
• Comes in pairs ( Passenger side and Driver side Turn Signals)
• Easy to apply and install.
• Perfect fitment guaranteed.
• Available in SMOKE, Light Smoked, Blue Smoke, JDM Yellow and Cherry Red

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap the entire Turn Signal to get rid of any debris or dust.
2. Peel the overlay off the backing.
3. Align the overlay at the edge that is closest to the headlight
4. Make sure it aligns to the top of the turn signal before laying everything flat.
5. Adjust the overlay as you see fit, but it will lay flush if aligned the top and corner next to headlight perfectly.
6. A padded card is not required, your fingers will work fine on laying the overlay on top of the reflector.
7. If you purchased Cherry Red, it may be best to install wet. Once desired placement is met, squeegee out the water and heat up the overlay to get rid of the any excess water underneath.
8. Swipe your finger towards the end of the overlay as you lay it down or move up and down while laying the overlay to improve adhesion and get rid of bubbles in the process.If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
9. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
10. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
11. After fully laying the overlay, heat up the overlay to insure no lifting and improved adhesion on the tint. Peel off the protective layer once done.