Rear Bumper Side Accent Pin-stripe Pre-cut Overlay for 2021-2025 Lexus IS300 IS350 IS500

Transform your 2021-2025 Lexus IS300, IS350, or IS500 with rear bumper side pin-stripe accents that demand attention. Easy to apply and available in a bold spectrum of colors, these stripes make your rear diffuser explode with style. Dare to show your aggressive, artistic edge and turn your bumper into a head-turning statement that breaks necks wherever you drive.

Specifications:

• Fitment: For 2021, 2022, 2023, 2024, 2025 Lexus IS 300 350 500 Rear Bumper Side Accent Pre-cut Overlay.
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
• Made with Durable Gloss Material
• Featured Overlays:
  • Orange on the side accent of the rear bumper
• Easy Application (Peel and Stick)
• Comes in (2 PCS) - Driver Side and Passenger side rear bumper
• ** NOTE ** Not Actual replacement of the side accent, this product is an overlay vinyl sticker that sticks onto the accent that sits below the reflector.

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your Rear Diffuser accents to get rid of debris before application
2. Peel off the overlay
3. Align the edge that is closest to the outside of the bumper 
4. Make sure the pin-stripe is centered on the diffuser accent
5. Once aligned, the rest should fall into place.
6. The more narrow edge will sit just at the end of the fang that points toward the middle of the bumper.
   
7. Make sure you have a padded card or soft glove to put on your fingers, if you do not, your fingers will do fine to smooth out the overlay onto difufser.
8. Swipe left and right gradually to reduce bubbles
9. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
10. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
11. If you mess up, you can peel it off right away, but slowly, then add some heat to get rid of the wrinkles.
12. For the Best application, use water underneath and squeegee out the water once the desired placement is met. (This Method only works if the backing has Oracle on it, But for this OVERLAY IT IS NOT NEEDED)
13. Once installed, always remember to HEAT UP THE OVERLAY to a hot but not scalding temperature to ensure tackiness and longevity.