Headlight Amber Delete for Elantra and Elantra N 2024+

Elevate your Elantra or Elantra N with our ultra high gloss Smoked Amber Delete or Gloss Black Amber Delete. This addition will bring a sense of cohesion and aggression to your Hyundai's front end, making it stand out. Designed for the 2021-2023 Hyundai Elantra and Elantra N. 

2024+ Hyundai Elantra and Elantra N Headlight Amber Delete (Smoke or Black Out)

• Fitment : [ 2024+Elantra ]
• Front of Headlight for the 2024+ Hyundai Elantra, Elantra N-line, and Elantra N
• High-Quality durable material. 5-year durability 
• Smoked made from Ultra-gloss nano-air tint Smoke
• Blackout made from 3M 2080 air release Wrap
• Comes in pairs ( Passenger side and Driver side Headlight )
• Easy to apply and install.
• Perfect fitment guaranteed.
• Available in SMOKE or BLACK OUT

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap the entire headlight to get rid of any debris or dust.
2. Align the corner of the amber delete right below where the LED and the black portion of the headlight meet, top of the .5" off the top of the amber.
3. The overlay will follow the curve of the headlight UNTIL the end.
4. The end tail will sit a little lower than being flush with the bottom of the LED white bar. This allows it to be seen from different angles without covering the white LED BAR.
5. A padded card is not required, however, it would be best to use one, since the amber delete is a larger piece of tint/blackout.
6. You can either start by laying the top portion of the headlight down, or vice versa.
7. DO NOT LAY it all starting from the sides, or it will be hard to lay everything down perfectly.
8. If using your fingers, start from the top of the amber delete, under the LED BAR, and use your fingers or (preferrably a padded card) to lay down the top portion of the amber delete and use your other hand to guide how the amber delete is laid.
9. Once the top portion is laid, heat up the rest of the overlay to a warm temperature and lay the bottom portion in one motion, you may pull and stretch/glass the rest down over the curve of the headlight as you may need to do so to get rid any wrinkles.
10. The 2nd portion of laying will take some time to get right, use a heat gun and work your way slowly down as it will take time and patience.
11. Once the desired placement has been met use a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
12. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge.
13. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
14. After fully laying the overlay, heat up the overlay to insure adhesion on the smoke/blackout. Peel off the protective layer once done.