AFD Overlays Front and Rear Pre-cut Emblem Overlays compatible with 2022+ WRX

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your reflector to get rid of debris prior to application
2. Peel off Emblem Overlay
3. Align one edge of the overlay (away from the middle bumper)
4. Make sure you have a padded card or soft glove to put on your fingers to begin laying the emblem on. If not, your fingers will work
5. If using your fingers, start from the one edge of the overlay working your way towards the middle of the bumper. Swipe left and right gradually to reduce bubbles. Your other hand will be holding the emblem and guiding placement as you lay down the overlay.
6. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion.
7. If there are bubbles make sure you press firmly with your finger and swipe in a circular motion till it disappears near the closest edge.
8. If you mess up, you can peel it off right away with no hassle
9. For Best application, use water underneath and squeegee out the water once the desired placement is met.

Notice of Non-Affiliation and Disclaimer:
We are not affiliated, associated, authorized, endorsed by, or in any way officially connected with Subaru, or any of its subsidiaries or its affiliates.

The names Crosstrek, Forester, Outback, Ascent, Solterra, Impreza, Legacy, Legacy, BRZ, WRX, STI as well as related names, marks, emblems and images are registered trademarks of their respective owners, including Subaru.

AeroFlowDynamics Overlays sells vinyl decals that are applied on top of your existing emblems. The listing images may show words that are trademarked and are used for illustration purposes only. Product is not affiliated with or endorsed by Subaru.

Overlays available for: Subaru, Crosstrek, Forester, Outback, Ascent, Solterra, Impreza, Legacy, Legacy, BRZ, WRX, STI 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025