2024+ Tesla Cybertruck Rear Bumper Reverse Light Pre-cut Overlay

2024+ Tesla Cybertruck Rear Bumper Reverse Light Pre-cut Overlay Tint

Transform your Tesla Cybertruck's rear reverse light with our 2024+ Rear Bumper Reverse Light Pre-cut Overlay Film. Select from four designs to add your flair. Our one-of-a-kind film enhances your cybertruck and distinguishes you from the rest. Take your ride to the next level and demonstrate your unique style now!

Specifications:

• Fitment: For 2024+ Tesla Cybertruck Rear Reverse Light
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
  
• Easy Application (Peel and Stick)
• Comes in (2 PCS) in a Pair (left and Right SMOKE OUT)
• ** NOTE ** Not Actual Reverse Light replacement, this product is an overlay that covers the existing reverse light with tint.

How to Install

For Best Results
Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your Rear bumper reverse light to get rid of dust and debris before application
2. Peel off the reflector tint
3. Note: if you mess up placement, peel off the overlay with ease. DO NOT heat up the overlay until the desired placement has been met.
4. This is made a tad larger to allow the overlay to cover the reverse light at the inner (near the middle of the bumper), top, and bottom flat surfaces.
5. Align the overlay at the edge of the pointed edge that is facing away from the middle of the rear bumper.
6. Lay everything down on the flat large surface (surface that faces toward you), you will have extra vinyl over the top, bottom, and inner reverse light.
7. Make sure it is all laid and tacked down then use a heat gun or blow dryer to begin heating up the edges of the overlay that hang over the reverse light.
8. The edges will start to conform to the edges of the reverse light.
9. Once you see it conforming, stop the heat and use your finger or squeegee to lay it flat onto the surfaces and tuck any vinyl into the cracks of the reverse light and bumper.
   
10. Once laid the rest of the overlay should fall into place, if not, use one of your free hands to guide the overlay till it covers the entire reflector.
11. Lay the overlay and adjust until the desired placement is met, lift if needed to adjust.
12. Once the placement is met, PLEASE FOLLOW BELOW INSTRUCTIONS FOR ADHESION
13. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
14. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
15. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
16. ** REMEMBER TO POST-HEAT** the vinyl after laying, this will activate the glue behind the overlay which will enhance tackiness.
17. NOTE:  LIGHT SMOKED has a PET liner, THAT must be peeled off after installation for a complete super gloss finish.