Tail Light Brake Light Pre-Cut Overlay for 2021+ Elantra N and Elantra N-Line

Upgrade the rear end of your 2021+ Elantra N or N-Line with this Tail Light Brake Light Pre-Cut Overlay. The sleek design adds an aggressive touch with showcasing only the red middle line (if choosing dark smoke), available in dark smoked or light smoke for a customized look. Say goodbye to bulky red tail lights and hello to a streamlined cyclops rear end.

2021+ Elantra N-line and Elantra N Brake Light Signal Smoke

• Fitment: For 2021+ Elantra N or N-Line Smoke Out Brake Light Signal
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
• Made with Smoked Ultimate Nano-Air Release Technology with Ultra Gloss finish
• Smoked Tint Vinyl Sticker, Changes Rear of Vehicle to Look More Aggressive 
• Easy Application
• Comes in Pair (left and Right SMOKE OUT)
• 4 pieces ( Driver Side Turn and Reverse | Passenger Side Turn and Reverse)
• ** NOTE ** Not Actual Tail Light Replacement, This product is an overlay that covers the existing CLEAR TURN SIGNAL / REVERSE LIGHT

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your Tail Light Break Light to get rid of debris before application
2. Peel off the Tail Light Tint Overlay
3. Starting with the outer brake light that sits on the bumper, align the overlay on the black portion inside the tail light and make sure the top portion of the overlay sits right at or below the black outline of the tail light at the top near the trunk.
4. Once laid, the rest should fall in place, you can also align from the trunk line then using your free hand guide the rest of the overlay to lay within the black outline INSIDE the tail light.
5. These black lines are where the tail light overlay will lay in.
6. Next peel the second tail light brake light (the one that sits on the tail light ON THE TRUNK ) off of the backing and line it where the trunk line stars.
7. Once tacked down and lined up, the rest of the overlay should fall into place. However, you may use your free hand to guide the overlay to the desired placement.
8. This portion will also fit inside the black lines and sit right below the black outline on the top, just after the red portion of the tail light ends.
9. Ensure you have a padded card or soft glove to put on your fingers to begin applying the overlay on the light. If not, your fingers will work
10. If using your fingers, start from left to right on the Driver's Side and Vice Versa for the Passenger side. Make your way towards the middle of the bumper or vice versa. Swipe left and right gradually to reduce bubbles.
11. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
12. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
13. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
    
14. Do not forget to post heat vinyl to increase tackiness and from lifting.
15. Once all the bubbles have been pushed out and overlay post-heated. PEEL OFF THE THIN PLASTIC COVER THAT SITS ON THE OVERLAY for a super gloss finish.