Rear Bumper Reflector Pre-cut Overlay Tint for 2024-2025 BMW X5

Rear Bumper Reflector Pre-cut Overlay Smoked for 2024-2025 BMW X5

Revamp your 2024-2025 BMW X5's Rear Bumper with our Rear Bumper Reflector Pre-cut Overlay! These sleek overlays add a touch of aggression to your ride, elevating its bold and daring style. The installation process is effortless, giving you the power to conquer the road. Choose from a variety of options - smoke, light smoke, or black out - and customize your ride with confidence!

• Fitment: For 2024-2025 BMW X5 Rear Bumper Reflector Overlay 
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
• Offered in Smoke Out, Light Smoke, Black Out, or Matte Black
• Easy Application, Peel and Stick.
• It comes in Pair (left and Right Tint for Rear Bumper Reflector)
• NOTE ** This is not an actual replacement of the reflector, it is a vinyl overlay.

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your reflector to get rid of debris prior to application
2. Peel off the Reflector Tint Overlay
3. Align the Reflector from the edge that points away from the middle of the rear bumper and work your toward the middle of the bumper
4. Make sure you have a padded card or soft glove to put on your fingers to begin applying the overlay on the light. If not, your fingers will work
5. If using your fingers, start from the pointy/curved edge of the overlay working your way towards the other side of the reflector. Swipe left and right gradually to reduce bubbles
6. Once you get to the edge that wraps into the tail gate, it is best to open the tail gate and continue wrapping
7. It may be a bit hard due to the limited access from the tail gate but work it slowly and you'll be able to lay the entire piece flat
8. It may be easier to heat up the edge that hangs off the flat portion that faces away from the bumper (the flat portion that faces directly towards your face)
9. Once that edge that wraps into the bumper is heated, it will be more malleable to navigate the vinyl onto the inner reflector
10. Ensure the edge is pulled slightly and flattened on the curve so no air is trapped prior to wrapping into the inside of the reflector
11. There may be some excess, just use a squeegee or fingernail to wrap the vinyl around the edges of the reflector
12. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
13. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
14. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
15. For the Best application, use water underneath and squeegee out the water once desired placement is met. (This Method only works if the backing has Oracle on it)