Rear Bumper Pin-stripe Accents Pre-cut Overlay for 2021-2025 IS500 F-sport

Enhance your 2021-2025 Lexus IS500 with rear bumper pin-stripe accents that capture every eye. These pre-cut overlays are easy to install and come in a range of vibrant colors, adding dynamic style to your rear diffuser. Show off your confident, creative side and make your bumper a striking feature that draws attention and admiration wherever you drive.

Specifications:

• Fitment: For 2021, 2022, 2023, 2024, 2025 Lexus IS500 F-Sport Rear Bumper Pin-stripes Accents Pre-cut Overlay.
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
• Made with Durable Gloss Material
• Featured Overlays:
  • Orange on each fang of diffuser and side accent of rear bumper
• Easy Application (Peel and Stick)
• Comes in (6 PCS) - Driver Side and Passenger side rear bumper, as well as middle of diffuser fangs
• ** NOTE ** Not Actual replacement of the side accent or diffuser middle fangs, this product is an overlay vinyl sticker that sticks onto the accents that sits below the reflector and on the diffuser.

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your Rear Diffuser accents to get rid of debris before application
2. Peel off the overlay
3. If starting with side accents - Align the edge that is closest to the outside of the bumper 
4. If starting with the middle accents of the diffuser - lay the top portion of the overlay right at the curve that rounds downward (that will be your guide on how high the overlay sits)
5. Make sure the pin-stripe is centered on the diffuser accent
6. Once aligned, the rest should fall into place.
7. The more narrow edge will sit just at the end of the fang that points toward the middle of the bumper.
   
8. Make sure you have a padded card or soft glove to put on your fingers, if you do not, your fingers will do fine to smooth out the overlay onto diffuser.
9. Swipe left and right gradually to reduce bubbles
10. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion
11. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
12. If you mess up, you can peel it off right away, but slowly, then add some heat to get rid of the wrinkles.
13. For the Best application, use water underneath and squeegee out the water once the desired placement is met. (This Method only works if the backing has Oracle on it, But for this OVERLAY IT IS NOT NEEDED)
14. Once installed, always remember to HEAT UP THE OVERLAY to a hot but not scalding temperature to ensure tackiness and longevity.