Front Bumper Fog Bezel Pin-stripe Pre-cut Overlay compatible with 2025+ Toyota Camry

Front Bumper Fog Bezel Pin-stripe Pre-cut Overlay compatible with 2025+ Toyota Camry

Enhance your 2025+ Camry's front bumper with our Front Bumper Fog Bezel Pin-stripe Pre-cut Overlay compatible with 2025+ Toyota Camry. This is a pin-stripe and does not cover or tint the actual fog lights. This product only fits Camry's without the foglight. Choose from various colors to personalize your vehicle and accentuate its already aggressive lines. Easy to install, this add-on is a simple way to change the look of your Camry's front bumper and add a touch of adventure to your ride!

Specifications:

• Fitment: For Toyota Camry SE / Toyota Camry XSE / Toyota Camry XLE/ Toyota Camry Hybrid Rear Bumper Reflector Smoked
• PICTURE FEATURES: Yellow
• High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability)
• Made with Durable High Gloss Material
• Easy Application (Peel and Stick)
• Comes in (2 PCS) in a Pair (left and Right Pin-stripe)
• ** NOTE ** NOT AN ACTUAL FOG LIGHT, This product is a vinyl overlay wrap that sits on top of the fog bezel trim. DOES NOT WRAP ACTUAL FOG LIGHTS.

How to Install

For Best Results

Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee

1. Rinse / Soap your front bumper fog bezel trim to get rid of debris before application
2. Peel off overlay accent pin-stripe overlays
3. Note: If you mess up placement, peel off the overlay easily. DO NOT heat up the overlay until you have met the desired placement.
4. Align the edge of the overlay that points TOWARD the middle of the car (top of the bezel trim). 
5. Tack the more pointed edge down first and use your free hand to guide the rest of the overlay.
6. Once you arrive at the curve of the trim, you will need to work slowly and bend the overlay with your free hand and your other hand to lay and guide the bend onto the bezel trim.
7. Once you pass the curve the rest should fall into place.
8. Lay down slowly and push out any bubbles as you lay it flat.
9. This may take some time, however, if you mess up, lift up the overlay and add some heat until the wrinkle disappears. Then re-apply to the desired placement.
10. Once all sections of the overlay is laid, depending on how you adjusted or pulled the piece, you may have some extra vinyl hanging off the end of the bezel.
11. You will need to wrap it around the edge of the trim by tucking it into the crevices or using a thin blade and cut off the excess.
    
12. Once placement is met, PLEASE FOLLOW THE INSTRUCTIONS FOR ADHESION.
13. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion.
14. If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge
15. If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles.
16. ** REMEMBER TO POST-HEAT** the vinyl after laying, this will activate the glue behind the overlay which will enhance tackiness.